- 16 -
3. Machine Setup & Installation
3.7 Loading Polypropylene Strap
Polypropylene Strap
Width: 5, 6 or 9mm
Thickness: 0.35-0.65 mm (0.014” –0.026”)
Note: Strap coil heavier than 12kg (27lbs) may damage the reel support system.
Note: Strap with excessive camber (see above) cannot be used.
3.8 Strap Reel Installation
1. Open the side door on the right side of the machine.
2. Lift the reel handle up all the way to the end.
3. Release the reel nut handle by pressing and turning it to the left.
4. Take out the outer flange.
5. Install a new strap coil onto the drum according to the instruction on the reel.
6. Put outer flange and the reel nut handle back. Turning the reel nut handle to the right to lock it.
To Next Page
Loading...