Eagle 710 - 1. Safety and Warnings; 1.1 Basic Operation; 1.2 Basic Safety Precautions

- 3 -
1. Safety and Warnings
1.1 Basic Operation
• Read the operation and safety manual prior to using the strapping machine.
• The operation and safety manual should remain attached to the machine at all times.
• The machine may only be operated in accordance with its designated use.
• The strapping machine was built in accordance with state-of-the-art standards and recognized
safety rules. Nevertheless, improper use can still result in injury to personnel or damage to the
machine and other material property.
• Machine shall only be operated by trained personnel.
• Perform inspections and maintenance at regular intervals. Refer to the Maintenance section of
the manual.
• The machine may not be put in operation before checking the respective devices.
• Safety devices must never be bridged or eliminated by any means.
• To transport the equipment only use lifting apparatus and loading devices with sufficient
capacity.
• Always disconnect from external power supply when changing the location of the machine,
even if the location should only be slightly changed. Connect power supply properly before
returning to service.
• Do not alter or bypass protective interlocks.
• Do not alter circuits and machine unless authorized to do so by the manufacturer.
1.2 Basic Safety Precautions
• In addition to the instructions for operation, the user is to be instructed in all generally
applicable legal or mandatory regulations relevant to safety or the environment.
• Long hair, loose-fitting garments, or jewelry can be a safety hazard. These items must be
secured prior to equipment operation.
• Use protective equipment whenever appropriate or when required by law.
• Carefully observe all safety instructions and warnings attached to the machine. Keep safety
labels clean and legible.
• People that are being trained to operate or service the equipment must be supervised by
experienced personnel.
• Any electrical work performed on the equipment must be conducted by a skilled electrician or
under the supervision of a skilled electrician. All work must be observed good electrical
engineering practice and follow safety rules and local wiring standards.