Serinus 40 User Manual 2.2
Installing the Instrument
1. Remove the rubber feet from the analyser (if attached).
2. Separate the slide rail assembly by pressing the black plastic clips on the slide rails to remove the
inner section of the rail (refer to Figure 73).
Figure 73 – Separate rack slides
3. Attach the inner slide rails to each side of the analyser using M4 x 10 button screws - three on
each side. Ensure the vertical slotted holes are used and push the slide firmly downwards so that
the screws sit at the top of the slot. This ensures that any protrusions under the base of the
analyser do not hit any blanking panels which may be fitted (refer to Figure 74).
Figure 74 – Assemble inner slide on chassis
4. Attach the rack mount adaptors to the ends of the outer slide rails using M4 x 10 button screws,
washers and locknuts. Do not fully tighten at this stage as minor adjustments may be required to
suit the length of the rack (refer to Figure 75).
To Next Page
Loading...
