VE-1010 Veterinary PC ECG User Manual Installing VE-1010 VET PC ECG Software
- 13 -
4.2 About Installation Interface
Insert the installation CD into CD-ROM, and double-click on Setup.exe
on the installation CD to open the following installation interface.
Figure 4-1 Installation Interface
Click on the Install button to install VET PC ECG. Click on the Next button continually during
installation.
After installing VET PC ECG, click on the Install button on the installation interface. Then the
Environment Detection interface pops up. Check the installing status of all the components. If
the Environment Detection interface shows that a certain component needs to be installed,
please install it manually.
Click on the Help button to see the installation guide.
For details on installing VE-1010 VET PC ECG software, please refer to VE-1010 Veterinary PC
ECG Installation Guide.
To Next Page
Loading...
Need help?
General
