VE-1010 Veterinary PC ECG User Manual Operation Instructions for Resting ECG
- 24 -
6.4.6 Stopping Sampling Data
After clicking on the Start button, there are two ways to stop sampling data.
1. The system will stop sampling ECG data and display the ECG analysis interface automatically
after the ECG sampling time is over. For details on setting ECG sampling time, see Section 9.2.2,
“Setting Sampling Time”.
2. Before the ECG sampling time is over, you can click on the Stop button to stop sampling data
and the ECG analysis interface will pop up automatically.
Note:
1. The Stop button is available 10 seconds after you click on the Start button in the
Resting ECG.
2. The Stop button is available 30 seconds after you click on the Start button in the
HRV ECG.
6.4.7 Printing ECG Waves
Click on the Print button on the ECG sampling interface to print the ECG waves on the Wave
Review interface.
Note: You can set the printer type on the print setup interface. There are two options:
white- black and color. The report color is defined by setting the printer type and
can be observed on the preview interface. For details on setting the printer type,
see Section 9.4, “Printer Setup”.
6.4.8 Freezing ECG Waves
Click on the Freeze button on the ECG sampling interface (Figure 6-5), the system will display
the Wave review interface. You can review the waveform by dragging the scrollbar.
To Next Page
Loading...
Need help?
General
