eddyfi Reddy - General Safety and Precautions

| xi
General Precautions and Conventions
General Precautions
The following safety precautions are to be observed at all times when using Reddy
®
. Make sure that you
review them before turning on the system.
• Keep this document in a safe place for future reference.
• Carefully follow the installation and operation procedures detailed herein.
• Respect the safety warnings on the instrument and in this document.
• Reddy should only be used by qualied personnel.
• When transpor ting Reddy, it is your responsibility to make sure that you apply the safety precautions
dictated by the relevant local governing bodies.
• Always connect the power supply to a properly grounded receptacle, extension cord, or power
bar. Grounding a single conductor of a two-conductor outlet is not sufcient protection for Reddy.
• Only connect the system to a power source corresponding to the type indicated on the rating plate.
• If you use the system in a manner that deviates from that specied by Eddy, the protection
provided on the equipment may be rendered null and void.
• Do not use substitute parts or perform unauthorized modications to the system.
• Service instructions, when applicable, are intended for trained service personnel only.
• Always make sure that the system is unplugged from any power supply before servicing.
• To avoid dangerous electric shock, do not perform any service on the system unless qualied to do
so. If you encounter any problems or have questions regarding this system, contact Eddy or an
authorized Eddy representative.
Safety Precautions
Observe the following safety precautions scrupulously when using Reddy.
Rear Stand
Because Reddy is a portable system, it is designed to be used under tough conditions. It is, however, not
indestructible. To avoid damaging Reddy, use its rear stand when operating Reddy in a tilted position.
Do not use Reddy in the upright position, as it may topple over or fall off the work surface.