eddyfi Reddy - Starting Reddy; Shutting down Reddy; Figure 1-3 Shutting down Reddy

| 9
Reddy Overview
Caution
It is possible to use Reddy while it rests on its lower bumpers, but this is not a safe operational
position as the instrument may fall over. If you want to use Reddy at an angle, use the stand located at
the rear of the instrument.
Important
Regardless of how you position the instrument, you must always have a minimum clearance of 10 cm
(4 in) on all sides of the instrument. Always position the instrument away from heat sources. This ensures
proper heat dissipation while the instrument is in use.
Starting Reddy
Proceed as follows to turn on your instrument or exit the standby mode:
1. Make sure that at least one of the two batteries is inserted into battery compartment A of the
instrument or that the instrument is plugged to an external power source using the supplied power
cord.
2. Press the power button.
The power indicator at the center of the power button lights green.
Shutting Down Reddy
Proceed as follows to shut down your instrument:
1. Save all your data.
2. Press the power button.
Three option buttons appear on the display.
Figure 1–3 Shutting down Reddy
3. Tap the button of your choice.
The instrument shuts down.