62 | www.eddy.com
Using the Optional Harness
4. Use the underarm straps and shoulder blade rings to adjust the t of your shoulder straps.
You may need to perform this adjustment several times to get the proper t.
Figure B–2 Adjusting the shoulder straps
5. Use the back and side belt straps to adjust the height of the harness’ belt to suit your body type.
You may need to perform this adjustment several times to get the proper t.
Note
Your belt’s height determines the lowest position of Reddy. Adjust this height so that the display of the
instrument is easy to see—for that, the belt could end up higher than your hips.
Figure B–3 Adjusting the belt’s height
6. Once your belt and shoulder straps are adjusted, clip and tighten the chest straps.
Figure B–4 Securing the chest straps
To Next Page
Loading...