| 49
Maintenance and Troubleshooting
Maintaining Reddy
®
Because of its design, Reddy only requires minimal maintenance. Since Reddy has no moving parts, it
also does not require any preventive maintenance on your part. We recommend a regular inspection of
the instrument to ensure that it is properly grounded. We also strongly recommends an annual calibr ation
and a factory-performed preventive maintenance by an ofcially qualied Eddy technician.
Cleaning Reddy
1. Make sure that the instrument is off and that the power cord is disconnected.
2. To bring the instrument back to its original nish, clean it with a soft cloth.
Warning
Do not spray the instrument with chemical cleansers or water. Doing so may lead to short circuits and
damage to the instrument.
Important
To remove stubborn stains, use a cloth moistened with soft, soapy solution. Do not use abrasives or
strong solvents as they could damage the nish. Wait until the instrument is completely dry before
connecting the power cord or cables.
Updating and Upgrading Magnifi
®
GO
Before you can perform any maintenance on Magni GO, you must rst meet the following requirements:
• USB mass storage device with a minimum of 4 GB free space ×1
• Hardwired Internet connection
There are two methods of updating or upgrading Magni GO.
Standard Method
1. Connect Reddy to a power outlet with the power cable.
2. Turn on Reddy and wait for Magni GO to start.
3. Download the *.ReddyOS le from the Eddy Web site.
Save the le in an easy-to-remember location on your computer.
4. Copy the *.ReddyOS to the root of a USB mass storage device.
5. Once copied, remove the mass storage device and connect it to one of Reddy’s two USB ports
A dialog box appears prompting you to proceed.
Important
Do not connect your mass storage device to the QuiCk Copy uSB port.
6. Tap Yes.
7. In the list that appears, tap OS Update, and then tap Update.
The instrument restarts. A window opens prompting you to conrm whether you want to update
the system.
8. To select Yes, press the keypad’s up arrow (see page 3). Press any other button to select No.
You are prompted to conrm again.
9. Pres the keypad’s up arrow again.
The update process starts. This normally takes between 5 and 10 minute, depending on the speed
of your mass storage device. When the process is complete, the system restarts.
10. Activate Windows.
See Activating Windows on page 50 for details.
To Next Page
Loading...