eddyfi Reddy - Page 6

vi | www.eddy.com
Figure 5–14 Component denition 35
Figure 5–15 Probe selection 35
Figure 5–16 Scan denition: congure scan 35
Figure 5–17 Scan denition: congure encoder and start position 36
Figure 5–18 Data denition: conguring lters 36
Figure 5–19 Indication codes 37
Figure 5–20 Display properties 37
Figure 5–21 Display layout 37
Figure 5–22 Nulling the Sharck probe 38
Figure 5–23 Sharck Assisted Calibration 38
Figure 5–24 Sharck Assisted Calibration: Calibration complete 39
Figure 5–25 Sharck probe on carbon steel weld 40
Figure 5–26 Probe origin and defect positioning along the scanning axis (probe shown top view)
40
Figure 5–27 Disabled functions during acquisition 41
Figure 5–28 Saving data 41
Figure 5–29 Flaw-like and spurious indications 42
Figure 5–30 Sizing information 43
Figure 5–31 Take screen captures with defect report entry check box 43
Figure 5–32 Selecting a layout 43
Figure 5–33 Entering a detected defect 44
Figure 5–34 Measurement methods 44
Figure 5–35 Report tab 45
Figure 5–36 Transverse C-scan 45
Figure 5–37 Report summary 46
Figure 5–38 Report options 46
Figure 5–39 Report summary 47
Figure 5–40 Inspection report 47
Figure 6–1 Options menu 50
Figure 6–2 System recovery interface 50
Figure B–1 Slipping the harness on 61
Figure B–2 Adjusting the shoulder straps 62
Figure B–3 Adjusting the belt’s height 62