Edwards nEXT400 User Manual

9. Storage
If possible, do not st
ore the pump for long-term. When long-term storage is necessary,
the pump should be set up and operated for minimum eight hours every six months.
To store the pump:
1. Put protecve covers over the inlet, outlet, interstage (for the 'i' nEXT only), purge,
booster (for the 'T' nEXT only) and vent ports.
2. Put the pump in its packing materials. Seal the pump in a plasc bag with a
applicable desiccant for fastest pump-down when the pump is put back into
service.
3. Store the pump in cool, dry condions unl necessary for use. Refer to Table:
Operaon and storage environment for recommended storage environment.
4. When necessary, prepare and install the pump as given in Installaon on page 37.
5. Always keep the pump upright to prevent the drainage of oil from the bearing
reservoir.
04/2022 - ©Edwards Limited
Page 93B80000880_G
B80000880_G - Storage

Edwards nEXT400 Specifications

General

Brand	Edwards
Model	nEXT400
Category	Water Pump
Language	English