Edwards nEXT730 - Page 48

B8J200880_E - Technical data
Page 47
Object name
Command
Parameter range
Factory
setting
Data type
Units
Comments
Timer options
!S870
0
1
decimal
-
Timer = disabled
?S870
1
-
-
-
Timer = enabled
Note that the timer is permanently
enabled on ramp-up.
Analogue signal
options
!S871
0
0
decimal
-
Analogue output = measured speed
?S871
1
-
Analogue output = measured power
2
Analogue output = measured motor
temp.
3
Analogue output = measured control
temp.
4
Analogue output = measured bearing
temp.
Electronic braking
options
!S872
0
0
decimal
Electronic braking = disabled
?S872
1
Electronic braking = enabled. Refer to
Electronic braking on page 19
Close vent valve
!C875
1
-
decimal
-
Closes the vent valve for delayed start
and overrides the current vent option.
There is no open vent valve command
but the stop command (!C852 0) will
clear the override.
Valve 1 type
!S877
0
0
decimal
-
Normally Open Valve
?S877
1
Normally Closed Valve
(power cycle is required)
Valve 2 type
!S878
0
0
decimal
-
Normally Open Valve
?S878
1
Normally Closed Valve
(power cycle is required)