ELDAN MPR200T - 4.1.1 Speed adjustment of the inlet conveyor (P.I.D)

Eldan Recycling A/S Page 13
4.1.1 Speed adjustment of the inlet conveyor (P.I.D).
Speed adjustment of the inlet conveyor is applied to get an even flow of
material into the MPR. Use the touch panel (see page 12) and type in the
Max. load value and the speed adjustment will keep up the load.
Use the speed adjustment to avoid overload of the MPR.
The speed adjustment reduces the speed if the MPR is loaded more than the
Max. load value, and increases the speed if the load is less than the Max. load
value.
If the speed of the inlet conveyor is too fast or too slow use the speed
adjustment to regulate the rate of speed.
To regulate the rate of speed, use the parameters for P.I.D.S. on the touch
panel.
MPR
06:37:37
11/04/06
Press the .
Load %
Motor 1
0 %
Rasper
ON
Outlet
ON
Inlet
ON
Rasper
OFF
Outlet
OFF
Inlet
ON
Curve Language
Alarm
List
Alarm
History
Adjustment
Load %
Motor 2
0 %
Rotor Speed
0
Temperatur
Fahrenheit MPR200
Temperatur
Fahrenheit Outlet
0 0
Time
Adjustment