ELDAN Recycling A/S Page 60
8.3 Adjustment of clutch
See Figure 18
When:
The clutch should be adjusted afte r the first 24 processing hours and
then for every 250 processing hours.
The clutch should be adjusted ever y time there has been an overload
and it has come to a complete stop of the rotor.
The clutch should be adjusted if the machine is running with very high
load, which means that it reac hes the overload SETTING POINT
many times/hour (between 10-50 overloads/hour).
How:
The counter nuts Figure 18, Pos. 2 are loosened.
The clutch bolts, Figure 18 Pos. 1, are tightened progressively in the
order shown on Figure 18. The order for the tightening is repeated un-
til all bolts have been tightened alike.
The final tightening for Figure 18 should be 65 Nm.
The counter nuts Figure 18, Pos. 2 are tightened again.
To Next Page
Loading...