8.5 Grinding of knives
Flying knife - 60mm
As the knives are extremely hard, it is recommended to have the
knives ground by a specialist. When gri nding the knives it is essential
to cool the knives so much that the structure and strength is un-
changed after grinding.
Damage due to incorrect grinding is at the customer’s own risk.
Figure 20
The knives should be ground as s hown on the marked areas, how-
ever, not further down than the indicated measures.
The knife bolts should be adjusted fo r every 24 hours operation or as
required. The bolts should be tightened to a torque of 320 Nm.
If the knives are ground more than stated on above sketch it will be at
the customer's own risk.
ELDAN Recycling A/S Page 63
To Next Page
Loading...