8.0 Introduction
Before the operator begins greasing/maintenance works on
the machine the following precautions should be followed:
By greasing and maintenance of the machine, the machine
should be brought to a complete stop and the main switches dis-
connected and locked.
After the machine has been stopped there is a caster time of
approx. 1 minute. Do not touch rotor, flywheel etc. before these
are completely stopped. Maintenance and repair etc. must not be
carried out before the rotating parts of the machine have stopped
completely.
When opening/closing the machine absolutely nobody, but the
operator must be in or near the machine.
Personal security when carrying out service work:
It is dangerous to climb the machine. Use either a platform or a
stepladder where service from the ground is impossible.
The processing area must be satisfactory illuminated so that
there are no dark corners. Illumination must, however, not be
dazzling. The supply must
not be taken from the machine as this
must be disconnected.
Use gloves for hand protection by maintenance work etc. The
machine can be very hot after continuous operation.
When cleaning the machine it is necessary to use dust masks.
When replacing the knives the use of safety glasses is necessary
because of the danger of splinters when the knives are exposed
to strokes and bumps.
ELDAN Recycling A/S Page 54
To Next Page
Loading...