6.0 Introduction
Within this section we have set out the setting instructions for the ma-
chine.
To enable you to get the best from your ELDAN machine it is essential
that it is set correctly.
Correct setting will make operation easier and will minimise mainte-
nance. Incorrect setting will course unnecessary breakdown and frus-
tration over product quality.
We therefore strongly recommend t hat setting becomes part of your
operational procedure.
6.1 Safety information
Before the operator begins greasing/maintenance work on the
machine the following precautions should be followed:
The main switch must be disconnected and locked before any
kind of maintenance, service or repair is carried out.
By greasing and maintenance of the machine, the machine
should be brought to a complete stop and the main switches dis-
connected and locked.
After the machine has been stopped there is a caster time of
approx. 1 minute. Do not touch rotor, flywheel etc. before these
are completely stopped. Maintenance and repair etc. must not be
carried out before the rotating parts of the machine have stopped
completely.
When opening/closing the machine absolutely nobody, but the
operator must be in or near the machine.
Personal security when carrying out service work:
It is dangerous to climb the machine. Use either a platform or a
stepladder where service from the ground is impossible.
ELDAN Recycling A/S Page 21
To Next Page
Loading...