ELDAN MPR200T - 6. SETTING THE MPR200 T

ELDAN Recycling A/S Page 20
6. SETTING THE MPR200T
6.0 Introduction .................................................................................................21
6.1 Safety information .......................................................................................21
6.2 Opening the upper part with hopper ............................................................23
6.3 Cleaning the Rasper and surrounding areas...............................................24
6.4 Information regarding adjustment/exchange of knives ................................25
6.5 Exchange of the static knives......................................................................27
6.6 Exchange of the flying knives......................................................................30
6.7 Adjustment of the distance between static and flying knives.......................33
6.8 Dismounting and mounting of knife holders for 25mm flying knives............34
6.9 Checking .....................................................................................................36
6.10 Closing the upper part with hopper..............................................................36
6.11 Removing the discharge hopper and the screen.........................................37
6.12 Mounting of the screen and discharge hopper ............................................40
6.13 Torque.........................................................................................................42
6.14 Motor ...........................................................................................................43