ELDAN MPR200T - 1.2 Stop procedure

202 pages

Save Page as PDF

To Next Page

To Previous Page

Eldan Recycling A/S Page 6

1.2 Stop procedure

Stop the Inlet conveyor.

Inlet

OFF

Stop the Outlet conveyor.

Outlet

OFF

The machine must be empty of material before the MPR is stopped.

Stop the MPR.

Rasper

OFF

Main Page

Table of Contents3
Introduction5
Safety Instructions6
Machine Information9
Equipment Description of MPR200T10
Input Definition10
Technical Specifications for MPR200T11
Safety Equipment13
Introduction14
Main Switch14
Emergency Stops14
Safety Switch14
Service Switch15
Fire Equipment for MPR200T16
Fire Hazard17
Installation18
Introduction19
Lifting Points19
Gravity and Weight Statement20
Recommended Floor Fixing Methods20
Dimensions of Clearance Needed for Service and Maintenance21
Power and Service Details and Requirements21
Test before Starting21
Foundations21
Setting the Mpr200T22
Introduction23
Safety Information23
Opening the Upper Part with Hopper25
Cleaning the Rasper and Surrounding Areas26
Information Regarding Adjustment/Exchange of Knives27
Exchange of the Static Knives29
Exchange of the Flying Knives32
Adjustment of the Distance between Static and Flying Knives35
Dismounting and Mounting of Knife Holders for 25Mm Flying Knives36
Checking38
Closing the Upper Part with Hopper38
Removing the Discharge Hopper and the Screen39
Mounting of the Screen and Discharge Hopper42
Torque44
Motor45
Operation46
Introduction47
Safety Statements47
Operational Procedure50
Useful Information Regarding the Process51
Steel and Dust Outlet53
Safety Statement Regarding Emergency Stops54
Maintenance55
Introduction56
Maintenance Directions58
Lubrication Scheme Summary60
Adjustment of Clutch62
Adjustment of Belt Drive64
Grinding of Knives65
Spare Parts68
Introduction69
Spare Parts Philosophy69
Spare Parts Stock Level Recommendations69
10. Disposal of the Mpr200T79
Start/Stop Procedure97
Start Procedure97
Stop Procedure99
Fault Messages100
Alarm History102
Setting: Load/Time104
Setting: Max. Load105
Speed Adjustment of the Inlet Conveyor (P.I.D)106
Procedure for Adjustment of the Inlet Conveyor109
Setting: Max. Overload111
Setting: Time Delay111
Setting: Time Delay (Inlet Conveyor)112
Setting: Water, Max. Temperature and Maxmax. Temperature113
Setting: Water114
Setting: Max. Temperature115
Setting: Maxmax. Temperature116
Setting: Changing Temperature Sensors MPR200 Ore Outlet117
Setting: Min. Rotor Speed118
Setting: Time Delay119
Viewing Load, Rotation Guard and Counter Time120
Counter Time121
Rotor Knife Counter Time122
Choose Language123
Setting: Time/Date124
Curves125
Load % Average Per Hour126
Servicing127
Turning the Rotor127
Pause Screen128
Pushbuttons129
Safety Switch130
Maintenance131
The Panel131
The Rest of the System131
14. Troubleshooting133
Control Panel137

ELDAN MPR200T - 1.2 Stop procedure

Table of Contents