Figure 2
4.4 Service switch
When operating the machine, the switch should be in Position "1".
By repair, maintenance and cleaning the se rvice switch should be set to Po-
sition "0" and removed.
The hydraulic pumping unit for opening of upper part with hopper as well as
screen can only be operated with the service switch in zero-position. Once
the upper part with hopper or screen is opened the hydraulic pump must be
switched off. At the same time the main switch must be disconnected and
locked.
Note: After the machine has been stopped a fixed period of time will have to
pass, before the switches can be released.
ELDAN Recycling A/S Page 13
To Next Page
Loading...