6.8 Dismounting and mounting of knife holders for 25mm flying
knives
Use gloves for hand protection by maintenance work etc. The ma-
chine can be very hot after continuous operation.
When replacing the knives the use of safety glasses is necessary,
because of the danger of splinters when the knives are exposed to
strokes and bumps.
It is important that all location surfaces are carefully cleaned.
Figure 10
1) Remove the wedge fixing bolts (Figure 10 – Pos 1)
2) Tighten wedge-jacking screws (Figure 10 - Pos. 2)
ELDAN Recycling A/S Page 34
To Next Page
Loading...