Eldan Recycling A/S Page 26
The MPR has a sensor, which measures the rotation of the rotor. The Min.
Rotor speed setting is used to ensure that the speed of the rotor does not fall
below the set value. If this happens, the MPR will stop.
Adjustment Min.
1. Press the Number to set the Min.
Rotor Speed.
Rotor S
eed
0
2. Enter the required number (50-160
seconds) and press Enter.
4.4.1 Setting: Time delay
The Time delay setting can be used to set a time delay so that the MPR does
not stop if the rotor speed dips briefly.
Adjustment
Time
1. Press the Number to set the Time
delay.
0
2. Enter the required number (1-3
seconds) and press Enter.
To Next Page
Loading...