6.4 Information regarding adjustment/exchange of knives
When considering the setting of t he MPR200T, the normal setting is
with regard to the knives and involves either
replacing the knives
or
setting the clearance between flying knives and static knives.
NB: By exchange of knives it is essential that all knives are re-
placed at the same time.
Set out in the 2 below checklists the order, in which these operations
should be undertaken, is shown. The remainder of this section sets
out the explanation as to how each operation should be undertaken.
The main switch must be turned off and locked
SETTING PLAN
KNIFE CLEARANCE SETTING
Order:
1) Release the safety switch for upper part
2) Open the upper part hydraulically and lock it in open position
3) Remove all loose material
4) Reset knife clearance
5) Recheck all bolts
6) Close the upper part hydraulically
7) Lock the safety switch for upper part
8) Sweep or vac the floor
KNIFE REPLACEMENT
Order:
1) Release safety switch for outlet hopper
ELDAN Recycling A/S Page 25
To Next Page
Loading...