2) Remove the outlet hopper
3) Open the screen holder hydraulically
4) Remove the screen from the screen holder
5) Remove all loose material
6) Liberate the safety switch for the upper part
7) Open the upper part hydraulica lly and lock the upper part in open
position
8) Remove static knives and flying knives
9) Clean all knife seats
10) Refit static and flying knives and set the knife clearance
11) Recheck all bolts
12) Close the upper part and lock the safety switch
13) Refit the screen in the screen holder
14) Close the screen holder hydraulically
15) Refit outlet hopper
16) Lock the safety switch for outlet hopper
17) Sweep or vac floor
Knife replacement means that all knives need to be replaced.
When setting the Rasper it is essential to use gloves for hand protec-
tion.
ELDAN Recycling A/S Page 26
To Next Page
Loading...