ELDAN Recycling A/S Page 58
8.2 Lubrication scheme summary
Machine Job Interval Quantity Product/type
MPR200T:
Main bearings Figure 17 - Pos. 1 F 100 H 30 g/each Shell Albida Grease EP2
Thrust bearing Figure 17 - Pos. 2 F 100 H 15 g Shell Albida Grease EP2
Slide bearing/couplings Figure 17 - Pos. 3 F ** 5 g/each Shell Albida Grease EP2
Hydraulic system Figure 17 - Pos. 4 O * 6 L Shell Tellus T46/68
Motors with grease nipple
Figure 17 - Pos. 7 F 1000 H 5 g/each Shell Albida Grease EP2
Job code: F = Grease O = oil
Interval code: H = hours U = weekly M = monthly
Quantity code: L = litres
Quantity code: g = grams
* Refilled as required/exchanged minimum once a year
** When the clutch slide
*** Refilled as required/exchanged after every 2000 hours.
**** Exchange the oil after 200 hours of operation and then after minimum every 2000 hours.
It is very important that the above items are lubricated in accordance with the mentioned specifications and that they are checked at
a regular basis and refilled if necessary.
SHELL's products are recommended - otherwise a similar product.
To Next Page
Loading...