ELDAN MPR200T - 9. SERVICING; 9.1 Turning the rotor

Eldan Recycling A/S Page 34
9. SERVICING
If the MPR has been started, there will be a two minute delay before the
machine can be opened.
9.1 Turning the rotor
When replacing a rotor knife, a service key can be used to rotate the rotor to
the desired position.
1. Turn the service key (OFF).
2. Remove the safety switches on the machine and open the machine.
3. Plug in the service key in the electricity socket on the machine (MPR).
4. Press Start/Reset to rotate the rotor.
5. Change the direction of the rotor by turning the middle switch on the
service key.
Start
Change direction
Start