ELDAN Recycling A/S Page 12
4.0 Introduction
In this section the safety equipment for the MPR200T will be described.
It is important that the instructions ar e followed very carefully to avoid dam-
age to the operator and the machine.
4.1 Main switch
The machine is equipped with a main swit ch, which can be locked. The main
switch disconnects all voltage to the machine and it is placed on the electrical
cabinet.
4.2 Emergency stops
The machine is equipped with two emer gency stops. One is placed on the
machine and one is placed on the electrical cabinet.
The function of the emergency stops is as follows:
1) When activated all volt age to the machine as well as inlet and outlet con-
veyors is disconnected immediately.
2) An emergency stop can only be reset deliberately. This does not mean
that the machine starts automatically, but only that it is possible to start the
machine again.
4.3 Safety switch
The MPR200T is equipped with a safety system, which protects the operator
from the rotating parts of the machine during maintenance work.
The greatest advantage of the system is that it also protects the operator
from the caster, which appears after the machine has been shut down elec-
trically.
The machine is equipped with a number of switches, which should be liber-
ated before hoppers, upper part etc. can be opened, see Figure 2.
The safety switch can be liberated, when the machine has been brought to a
complete stop and the service key on the electrical cabinet is in zero-position.
Note: After stop a certain period of time must pass, before the switches can
be liberated.
To Next Page
Loading...