Eldan Recycling A/S Page 43
Other troubleshooting
Function Fault Possible fault
MPR Fails to start
Check that the control current
(L351) lamp is lit. If not, check all
emergency stops. Turn the
control current key (B351) and
press the Start/Reset button
(B299).
Check the Alarm list.
Fault Possible fault
The system fails to operate or the touch
panel will not switch on.
Check the power supply.
Check the main fuses.
Check the fine fuses for the control
current transformer.
Or contact a technician.
If the fault is not covered by the above examples, the system may be
defective. Contact a service technician.
NB: Pos. (?) is a reference to the position of the component in the
pumping station. The position number is taken in accordance with the
manual from the pumping station.
To Next Page
Loading...