ELDAN Recycling A/S Page 50
5. Size of the fractions
The knives have to be set if:
- The use of ampere is rising, but the material flow is the same.
- The conveyors are constantly stopping (operational manual)
- The granules are not cut through but "grated".
- The capacity is degressive.
It is recommended to adjust the knives after 8 hours of operation and
then as required.
The sharp edges of the knives disa ppear rather quickly and it is
therefore recommended to adjust the clearance betw een the
knives after a couple of hours opera tion. This w ay it w ill be pos-
sible to obtain max. capacity on the machines.
Subsequent the knives should be adj usted as described above and in
“Maintenance Directions”.
To Next Page
Loading...