ELDAN MPR200T - Page 94

Eldan Recycling A/S Page 1
Contents
Page
1. START/STOP PROCEDURE................................................. 4
1.1 Start procedure......................................................................................................4
1.2 Stop procedure ......................................................................................................6
2. FAULT MESSAGES ............................................................. 7
3. ALARM HISTORY................................................................ 9
4. SETTING: LOAD/TIME........................................................11
4.3.0 Setting: Max. Load...............................................................................................11
4.3.0 Setting: Max. Load ...........................................................................................12
4.1.1 Speed adjustment of the inlet conveyor (P.I.D).........................................13
4.1.2 Procedure for adjustment of the inlet conveyor.........................................16
4.3.0 Setting: Max. Overload ....................................................................................18
4.2.1 Setting: Time delay .........................................................................................18
4.2.2 Setting: Time delay (Inlet conveyor)................................................................19
4.3.0 Setting: Water, Max. Temperature and MaxMax. Temperature. ......................20
4.3.1 Setting: Water ..................................................................................................21
4.3.2 Setting: Max. Temperature .............................................................................22
4.3.3 Setting: MaxMax. Temperature.......................................................................23
4.3.4 Setting: Changing Temperature Sensors MPR200 ore Outlet. ........................24
4.4.0 Setting: Min. Rotor Speed...............................................................................25
4.4.1 Setting: Time delay ...................................................................................26
5. VIEWING LOAD, ROTATION GUARD AND COUNTER TIME
...........................................................................................27
5.1 Counter time........................................................................................................28
5.2 Rotor knife counter time ......................................................................................29
6. CHOOSE LANGUAGE.........................................................30
7. SETTING: TIME/DATE........................................................31