ELNA XPRESSIVE 2 - Inserting a Stitch

114
 Normal changes the stitch to a
standard stitch.
 Tension0 sets the thread tension.
 Tension1 sets the thread tension.
 Tension2 sets the thread tension.
 Trim inserts a trim at the selected
stitch.
 Jump inserts a jump stitch at the
selected stitch, instead of dropping
the needle when the design is sewn
out.
 Stop inserts a machine stop at the
selected stitch. A stop can also
represent a color change.
Inserting a stitch
You can insert one or more stitches into a
design file.
To insert a stitch:
1 Open a Xpressive Unified File (*.ESX) or
any other design file.
2 Select the stitch that will have stitches
inserted before or after.
For more information, see "Selecting
stitches in various ways".
The stitch becomes highlighted.
3 Press Ctrl+E on your keyboard and
choose one of the following:
 Choose Insert Stitch—Before to insert
the stitch before the highlighted stitch.
 Choose Insert Stitch—After to insert
the stitch before the highlighted stitch.
To undo the stitches you added, press
BACKSPACE on your keyboard.