94
Specifying the underlay
density
You can specify the density for underlay
stitches. Just like density for your top
stitches, underlay density is measured in
embroidery points (pts) and stitches per inch
(spi). In embroidery points, you measure the
distance between stitches. In stitches per
inch, you determine the number of stitches
per inch.
To set the underlay density:
1 Select the segment.
2 Click the Segment Settings
tool on
the ribbon.
You see the Segment Settings property
pages.
3 Click the Underlay property page.
4 In the Type area, select one of the
following underlay types:
Contour
Perpendicular
5 In the Density (+/-) box, enter the density
value in pts.
The default is 20.0 pts.
6 Click OK.
Specifying the underlay
stitch length
You can specify the stitch length for your
underlay stitches. You can increase or
decrease the length according to your
underlay needs.
To specify the underlay stitch length:
1 Select the segment.
2 Click the Segment Settings
tool on
the ribbon.
You see the Segment Settings property
pages.
3 Click the Underlay property page.
4 In the Type area, select one of the
following underlay types:
Contour
Perpendicular
5 In the Stitch Length box, enter the stitch
length that you want for your underlay
stitches.
The default is 25.0 pts.
6 Click OK.
Changing Commands
properties
Adding machine
commands
You can add specific machine commands to
your design such as stops, jumps, and
changeovers.
You can combine underlay types to get
maximum coverage.
You can combine underlay types to get
maximum coverage.
To Next Page
Loading...
