ELNA XPRESSIVE II 165
User’s Guide
Appliqué
Creating an appliqué
border
Use the Appliqué tool to create an
appliqué border around your appliqué. An
appliqué border is similar to a Steil stitch
border.
You can find Appliqué settings within the
Appliqué segment settings property page.
To create an appliqué border
1 In the Punching toolbar, click the Appliqué
tool.
The pointer becomes a cross hair.
2 Click the Segment Settings tool on
the ribbon.
You see the Segment Settings property
page.
3 Select the Appliqué property page and
make changes to settings.
4 Click OK.
5 Do one of the following to punch the
segment:
To create an open segment, click the
design workspace to place the anchor
points in your design.
To create a closed segment, click the
design workspace to place the anchor
points in your design. Click the Auto
Close tool on the ribbon or press
H on your keyboard to close the
segment.
6 To complete the segment, press ENTER
on your keyboard.
Programmed Runs
Using Programmed Runs
A Programmed Run is a Run segment that
uses a Programmed Fill pattern. Refer to the
Fill online Help located in Help—Fills to view
the Programmed Fill patterns available.
To create Programmed Runs:
1 In the Punching toolbar, click the Run
tool.
The pointer becomes a cross hair.
2 Click the Segment Settings tool on
the ribbon.
You see the Segment Settings dialog
appear.
3 Click the Run property page.
4 In the Run Style list, select Programmed.
5 In the Programmed Fill Pattern list, select
a Programmed Fill pattern.
6 Click OK.
7 Do one of the following steps to punch a
Programmed Run segment:
To create an open segment, click the
design workspace to place the anchor
points in your design.
To create a closed segment, click the
design workspace to place the anchor
points in your design. Click the Auto
Close tool on the ribbon or press
H on your keyboard to close the
segment.
8 To complete the segment, press ENTER
on your keyboard.
Xpressive applies the Programmed Fill
pattern to the Run segment.
To Next Page
Loading...
