ELNA XPRESSIVE 2 - Keyboard Commands

186
Keyboard Commands
The following keyboard commands do not
have corresponding menus or tools. The only
way to access them is through keyboard
keys.
Action Key
Design Workspace
Toggle between the
Select (Outline)
tool and the Stitch
Select tool (One
of these tools must be
enabled).
Spacebar
Toggle between the
Run tool and the
previously used
punching tool (The
Run tool or a punching
tool must be enabled).
Spacebar
Pan Arrow keys (←↑→ ↓)
Also (Home, End,
PgUp PgDn)
Highlight cursor
(mouse finder)
Shift+F
Add Guidelines
(reference lines)
Ctrl+J
Move Guidelines Ctrl+Shift (press and
hold the Ctrl and Shift
keys as you click and
drag the guideline off
the screen)
Zoom in while
punching
Press + on the number
keypad to zoom in.
Zoom out while
punching
Press - on the number
keypad to zoom out.
Backup to previously
punched point
Backspace
Editing
Expand stitch picking
radius (doubles the
search radius). This
feature is helpful if
you’re having
problems picking a
point when you’re
zoomed in.
Hold down Shift
Delete multiple
stitches in Stitch file
Backspace
When using any path
drawing tool you can
force your line to be at
an angle. Shift forces
the next point to be at
any 15 degree
increment angle (0 to
90 degrees).
Press Shift while
punching
Set Start/Stop tool to
enter start and stop
points
Tilde key (~) or
Semicolon key (;)
Close a segment H
Nudge anchor points Select anchor point
with Vertex Select and
use Alt + arrow keys
(←↑→ ↓)
Enhanced Bezier
entry modes
Straight mode Left-click
Bezier mode Ctrl
Action Key