154s
To auto trace images:
1 Choose Image—Load to load the image
you want to trace.
For more information, see "Loading
images for punching".
You will see the image in the design
workspace.
2 In the Punching toolbar, click the Complex
Fill , Run , Manual , Steil ,
or Appliqué tools.
You can auto trace by clicking on any
punching tool that supports closed
shapes: Complex Fill, Run, Manual, Steil
or Appliqué. This results in a segment of
that type.
3 To use Auto Trace mode, click the Auto
Trace tool on the ribbon.
You will see the cursor change into a
tracing tool.
4 To trace, a portion of the image, click the
image.
5 To keep the traced paths, press ENTER
on your keyboard.
To Next Page
Loading...
