ELNA XPRESSIVE 2 - Page 82

80
2 Do one or more of the following to change
the size and position of the lettering:
Do this Get this
Change the height of
the lettering and not
affect the lower
baseline.
At the top of the lower
baseline, drag the
white square bead.
Change the height of
the lettering and not
affect the upper
baseline.
At the top of the upper
baseline, drag the
white square bead.
Change the position
and size of the upper
baseline.
Click and drag the top
overlapping square
bead at the center.
Do this Get this