To Next Page

To Previous Page

CAUTION

The portable lift commonly used by EMC service personnel has two

configurations - one with the lower mast only and one with both the lower and

upper masts. The lower mast configuration is rated for 400 pounds and is for

raising or lowering objects 28U (49 inches) or less above the floor. The dual mast

configuration is rated well under 200 pounds and is for raising objects more than

28U (49 inches) above the floor.

For installations at or below 49 inches, you must use the lower mast

configuration.

For installations above 49 inches, use the "Voyager" conversion kit, rated for

225 pounds, and a support table with the lower mast configuration.

Reconfiguring the lift with Voyager kit

If you are using the Alum-A-Lift for installations or removals above 49 inches (28U),

you must use the single (lower) mast configuration with the "Voyager" conversion kit

and support table.

NOTICE

The "Voyager conversion kit," is used with multiple systems.

Procedure

1. Unpack the Voyager kit.

2. Use the instructions to provided within the kit to reconfigure the lift.

Figure 4

Reconfiguring the portable lift with the Voyager conversion kit

CL5422

1 2

Shelf Installation and Removal

26 EMC Data Domain DS60 Expansion Shelf Installation and FRU Replacement Hardware Guide

Questions and Answers:

Need help?

Do you have a question about the EMC Data Domain DS60 and is the answer not in the manual?

EMC Data Domain DS60 Specifications

General