Figure 29 Locking the Casters
5. Using the cordless drill that comes with the Voyager conversion kit, place the
cordless drill over the hex fitting and use the drill to raise or lower the arm to
the required height. With the node extended from the rack on the rails, pull the
shelf from the rails and onto the lift. Secure the shelf to the portable lift using
the securing straps as follows:
Figure 30 Removing a Shelf from rails more than 49" above the floor
a. Place the securing strap around the lift and the shelf.
Shelf Installation and Removal
46 EMC Data Domain DS60 Expansion Shelf Installation and FRU Replacement Hardware Guide
To Next Page
Loading...