Emerson Affinity - Page 271

Affinity User Guide 271
Issue Number: 5 www.controltechniques.com
H
Hazardous areas .....................................................................21
Heatsink mounted braking resistor ..........................................76
High speed operation ............................................................128
Hold zero speed
....................................................................111
Humidity ................................................................................239
I
I/O module category parameters ...........................................194
Input current ratings ..............................................................241
Input inductor calculation
........................................................70
Internal EMC filter ...................................................................80
Isolator switch .........................................................................86
Items supplied with the drive
...................................................19
K
Keypad and display - fitting / removal .....................................29
Keypad operating mode
Auto
................................................................................216
Hand
..............................................................................216
Off ..................................................................................216
Keypad operation
....................................................................93
L
Line power supply loss modes ..............................................222
Line reactors
.................................................................. 70, 238
Location ...................................................................................23
Low load ................................................................................110
M
Maximum speed / frequency ................................................ 128
Mechanical Installation ........................................................... 20
Menu 0 .................................................................................... 95
Menu 01 - Frequency / speed reference
.............................. 146
Menu 02 - Ramps ................................................................. 150
Menu 03 - Slave frequency, speed feedback and speed
control
............................................................................. 153
Menu 04 - Torque and current control .................................. 156
Menu 05 - Motor control ....................................................... 159
Menu 06 - Sequencer and clock
........................................... 163
Menu 07 - Analog I/O ........................................................... 165
Menu 08 - Digital I/O ............................................................. 168
Menu 09 - Programmable logic, motorized pot and binary
sum .................................................................................. 171
Menu 10 - Status and trips
................................................... 175
Menu 11 - General drive set-up
............................................ 177
Menu 12 - Threshold detectors and variable selectors ......... 178
Menu 14 - User PID controller
.............................................. 186
Menu 15 and 16 - Solution Module set-up
............................ 193
Menu 17 - Building Automation Network .............................. 212
Menu 18 - Application menu 1
.............................................. 212
Menu 19 - Application menu 2
.............................................. 212
Menu 20 - Application menu 3 .............................................. 212
Menu 21 - Second motor parameters ................................... 213
Menu 22 - Additional Menu 0 set-up
..................................... 214
Menu structure ........................................................................ 94
Minimum connections to get the motor running in any
operating mode
............................................................... 116
Mode parameter ..................................................................... 88
Model number ......................................................................... 14
Monitoring
............................................................................. 107
Motor (running the motor) ..................................................... 115
Motor cable - interruptions ...................................................... 86
Motor isolator / disconnector-switch
....................................... 86
Motor map parameters ......................................................... 121
Motor number of poles ..................................................121, 124
Motor operation
...................................................................... 75
Motor parameters ................................................................. 112
Motor rated current
.......................................................121, 124
Motor rated frequency
..................................................121, 124
Motor rated power factor
..............................................121, 124
Motor rated speed
........................................................121, 124
Motor rated voltage
.......................................................121, 124
Motor requirements
.............................................................. 239
Motor thermal protection
....................................................... 127
Motor winding voltage
............................................................. 75
Mounting methods
.................................................................. 31
Multiple motors
....................................................................... 75
N
Nameplate description ............................................................ 15
NEMA rating ...................................................................50, 239
Notes ........................................................................................ 7