Emerson Unidrive M702 - Page 23

Safety
information
Product
information
Mechanical
installation
Electrical
installation
Getting
started
Basic
parameters
Running
the motor
Optimization
NV Media Card
Operation
Onboard
PLC
Advanced
parameters
Technical
data
Diagnostics
UL listing
information
Unidrive M702 User Guide 23
Issue Number: 3
Figure 3-4 Removing the size 3 terminal covers
1. Control / AC / Motor terminal cover
2. DC / Braking terminal cover
On size 3 drives, the Control / AC / Motor terminal cover must be removed before removal of the DC / Braking terminal cover. When replacing the
terminal covers, the screws should be tightened to a maximum torque of 1 N m (0.7 lb ft).
Figure 3-5 Removing the size 4 terminal covers
1. Control / AC / Motor terminal cover
2. DC / Braking terminal cover
On size 4 drives, the Control / AC / Motor terminal cover must be removed before removal of the DC / Braking terminal cover. When replacing the
terminal covers, the screws should be tightened to a maximum torque of 1 N m (0.7 lb ft).
1
2