Emerson Unidrive M702 - Quick Access Mode; Keypad Shortcuts; Display Modes

Safety
information
Product
information
Mechanical
installation
Electrical
installation
Getting
started
Basic
parameters
Running
the motor
Optimization
NV Media Card
Operation
Onboard
PLC
Advanced
parameters
Technical
data
Diagnostics
UL listing
information
Unidrive M702 User Guide 89
Issue Number: 3
Figure 5-2 Display modes
The navigation keys can only be used to move between menus if Pr 00.049 has been set to show 'All Menus'. Refer to section 5.9 Parameter access
level and security on page 93.
5.2.2 Quick access mode
The quick access mode allows direct access to any parameter without
scrolling through menus and parameters.
To enter the quick access mode, press and hold the Enter button
on the keypad while in ‘parameter mode’.
Figure 5-3 Quick access mode
5.2.3 Keypad shortcuts
In ‘parameter mode’:
• If the up and down keypad buttons are pressed
together, then the keypad display will jump to the start of the
parameter menu being viewed, i.e. Pr 05.005 being viewed, when
the above buttons pressed together will jump to Pr 05.000.
• If the left and right keypad buttons are pressed together,
then the keypad display will jump to the last viewed parameter in
Menu 0.
In ‘parameter edit mode’:
• If the up and down keypad buttons are pressed
together, then the parameter value of the parameter being edited will
be set to 0.
• If the left and right keypad buttons are pressed together, the
least significant digit (furthest right) will be selected on the keypad
display for editing.
To enter Edit Mode,
press key
Status
Mode
(Display
not
flashing)
Parameter
Mode
(Upper row
display flashing)
Edit Mode
(Character to be edited in lower line of display flashing)
Change parameter values
using keys.
When returning
to Parameter
Mode use the
keys to select
another parameter
to change, if
required
To enter Parameter
Mode, press key or
Temporary
Parameter
Mode
(Upper display
flashing)
Timeout
Timeout
To return to Status Mode,
RO
parameter
R/W
parameter
To select parameter
Press
To return to Parameter Mode,
Press key to keep the new parameter value
Press key to ignore the new parameter value and return
the parameter to the pre-edited value
Press key
Timeout
or
Press key
NOTE