Emerson Unidrive M702 - Removal of a Standard Option Module; Installation and Removal of a Large Option Module

Safety
information
Product
information
Mechanical
installation
Electrical
installation
Getting
started
Basic
parameters
Running
the motor
Optimization
NV Media Card
Operation
Onboard
PLC
Advanced
parameters
Technical
data
Diagnostics
UL listing
information
28 Unidrive M702 User Guide
Issue Number: 3
Figure 3-12 Removal of a standard option module
• Press down on the tab (1) to release the option module from the drive housing, the tab is highlighted in the detailed view (A).
• Tilt the option module towards you as shown (2).
• Totally remove the option module in direction shown (3).
Figure 3-13 Installation and removal of a large option module
Installing a large option module
• Move the option module in direction shown (1).
• Align and insert the option module tabs (A) into the slot provided (B).
• Press down on the option module until it clicks into place.
Removing a large option module
• Press down on the tab (2C), tilt the option module towards you and remove.
The large option module can only be inserted into slot 3. Additional standard option modules can still be installed and used in slot 2 and slot 1.
NOTE