Emerson Unidrive M702 - Page 71

Safety
information
Product
information
Mechanical
installation
Electrical
installation
Getting
started
Basic
parameters
Running
the motor
Optimization
NV Media Card
Operation
Onboard
PLC
Advanced
parameters
Technical
data
Diagnostics
UL listing
information
Unidrive M702 User Guide 71
Issue Number: 3
Figure 4-24 Removal of the size 4 internal EMC filter
To electrically disconnect the Internal EMC filter, remove the screw as
highlighted above (1).
Figure 4-25 Removal of the size 5 internal EMC filter
Remove the three M5 terminal nuts (1). Lift away the cover (2) to expose
the M4 Torx internal EMC filter removal screw. Finally remove the M4
Torx internal EMC filter removal screw (3) to electrically disconnect the
internal EMC filter.
Figure 4-26 Removal of the size 6 internal EMC filter
To electrically disconnect the Internal EMC filter, remove the screw as
highlighted above (1).
Figure 4-27 Removal of the size 7 and 8 internal EMC filter (size 7
shown)
To electrically disconnect the Internal EMC filter, remove the screw as
highlighted above (1).
1
2
3
1
1