Empisal EES50 - Using the Needle Threader

15
Using the needle threader
Attention:
Turn power switch to the off position ("O").
Raise the needle to its highest position
and lower the presser foot.
1
Lower the needle threader lever slowly and
draw the thread through the thread guide as
illustrated and then to the right.
1
2
The needle threader automatically turns to
the threading position and the hook pin
passes through the needle eye.
2
3
Take the thread in front of the needle.
3
4
Hold the thread loosely and release the
lever slowly. The hook will turn and pass the
thread through the needle eye forming a
loop.
Pull the thread through the needle eye.
4