Replacing the
needle
Attention:
B
A
Turn power switch to off ("O") when carrying out
any of the above operations!
Change the needle regularly, especially if it
is showing signs of wear and causing
problems.
Insert the needle following the illustrated
instructions.
A. Loosen the needle clamp screw and
tighten again after inserting the new needle.
The flat side of the shaft should be towards
the back.
B. Insert the needle as far up as it will go.
Needles must be in perfect condition.
Problems can occur with:
- Bent needles
- Blunt needles
- Damaged points
To raise or drop the feed
dogs
With the sewing table off the machine, the
feed dog adjustment lever can be seen on
the base in back of the sewing machine.
Sliding the lever to the " " (b) will lower the
a
feed dog, for example during button sewing. If
you wish to continue sewing normally, slide the
lever to the " " (a) in order to raise the feed
dogs.
b
The feed dog will not rise up if you do not turn
the handwheel, even if the lever is slid to the
b
a
right. Make a complete turn to raise the feed
dogs.
To Next Page
Loading...
