Empisal EES50 - Darning Stitch

45
Darning stitch
2mm
4
5
4
Position the fabric so that the needle is 2mm
(1/16 inch) in front of the area to be darned,
and then lower the presser foot lever.
Please Note:
When lowering the presser foot, do not push
in the front of the presser foot, otherwise the
darning will not be sewn with the correct size.
5
Pass the upper thread down through the
hole in the presser foot.
Pull down the buttonhole lever. The
buttonhole lever is positioned behind the
bracket on the buttonhole foot.
Gently hold the end of the upper thread in
your left hand, and then start sewing.
Please Note:
When you select any buttonhole pattern or
darning pattern, the LCD screen will display
the figure " " to remind you to lower the
buttonhole lever.
A-27
A-26
6
Darning stitches are sewn from the front of
the presser foot to the back, as shown.
Please Note:
If the fabric does not feed, for example,
because it is too thick, increase the stitch
length.
If the sewing range is too big to sew, then
we suggest you can sew several times (or
cross sew) to get better sewing result.
6