Empisal EES50 - Cording; Single Cording; Triple Cording

49
Cording
Used for embellishing 1 to 3 cords or decorative threads.
Sew over one strand of cording to create a pretty swirled design on a jacket or vest or sew
over three strands of cording for border trims. Pearl cotton, knitting yarn, embroidery floss,
lace thread, fine wool or lily yarn can be used for cording.
* The cording foot accessory is optional. It is not included with this machine.
5
M
Single cording
Mark the design on the fabric.
Insert the cord in the center groove of the
cording foot from the right side opening.
Place the cord under the grooves of the
cording foot and pull the cord about 5cm (2
inches) behind the foot.
The grooves under the foot will hold the length
of the cord in place while the stitches are being
form over the cord.
Select the stitch and adjust the stitch width so
that the stitches are just covering the cord.
Lower the foot and sew slowly, guiding the cord
over the design.
6 A-10
M
Triple cording
Mark the design on the fabric.
Insert three cords into the grooves of the foot
from the right side opening.
Place the cord under the grooves of the
cording foot and pull the cord about 5cm (2
inches) behind the foot.
The grooves under the foot will hold the length
of the cord in place while the stitches are being
form over the cord.
Select the stitch and adjust the stitch width so
that the stitches are just covering the cord.
Lower the foot and sew slowly, guiding the cord
over the design.