This foot can be set to sew on each side of the zipper, the The edge of the foot guides
the
zipper to ensure
straight placement.
1
I
3.5 1.5~3.0
5mm
Attention:
Zipper foot should be used for sewing width
center needle position straight stitch only. It
is possible that needle could hit the presser
foot and break when sewing other patterns.
Inserting
a centered
zipper
1
Place the right sides of the fabric together.
Sew a bottom seam 2cm from the right edge
Reverse
stitches
Basting
stitching
Reverse
side
Basting
stitching
Reverse
side
to the zipper bottom stop position. Sew a
few stitches in reverse to lock. Increase the
stitch length to maximum, set the tension
below 2, and baste the remaining length of
the fabric.
2
Press open the seam allowance. Place the
zipper face down on the seam allowance
with the teeth against the seam line. Baste
the zipper tape.
1
2cm
2
3
Attach the zipper foot. Attach the right side
of the presser foot pin to the holder when
sewing the left side of the zipper.
4
Attach the left side of the presser foot pin to
the presser foot holder when sewing the
right side of the zipper.
3
4
5
Stitching around the zipper.
Please
Note:
When sewing, be sure that the needle does
not touch the zipper, otherwise the needle
may bend or break.
6
Remove the basting and press.
5
6
To Next Page
Loading...
