A-00
T
Changing the needle
position
–
0.0 2.0 3.5 5.0 7.0
These setting apply only to Direct Patterns 1-4, or A
Group Pattern 00. The pre-set position is "3.5",
center position. When you press the " " of stitch
width adjustment button, the needle position will be
moved to the left. When you press the "+" of stitch
width adjustment button, the needle position will be
moved to the right. On the LCD screen, the point
illustration and the number indicate the needle
position.
–
Changing the stitch
l
ength
0.5
1.0
2.0
3.0
4.5
To shorten the stitch length, press the " " of stitch
length adjustment button. For a longer stitch length,
press the "+" of stitch length adjustment button.
Generally speaking, the thicker the fabric, thread
and needle, the longer the stitch should be.
Zigzac
stitches
T
0.0
0.5
1.0
1.0
3.0
2.0
5.0
3.0
7.0
4.5
Adjusting
the stitch
w
idth
The maximum zigzag stitch width for zigzag
stitching is "7.0" ; however, the width can be
reduced on any patterns. The width increases as
you press the " + " of stitch width adjustment button
from "0.0-7.0".
Adjusting
the stitch
l
ength
The density of zigzag stitches increase as the
setting of stitch length approaches "0.3".
Neat zigzag stitches are usually achieved at "1.0-
2.5".
Closed up zigzag stitches (close together) are
referred to as a satin stitch.
To Next Page
Loading...
