Empisal EES50 - Changing the Presser Foot

20
Changing the presser foot
Attention:
Turn power switch to off ("O") when carrying out any of the below
operations!
a
1
Attaching the presser foot holder
Raise the presser foot bar (a).
Attach the presser foot holder (b) as illustrated.
1
b
a
2
Attaching the presser foot
Lower the presser foot holder (b) until the cut-out (c) is directly
above the pin (d).
e
Press the black lever (e).
Lower the presser foot holder (b) and the presser foot (f) will
b
c
engage automatically.
d
f
2
3
Removing the presser foot
Raise the presser foot.
e
Press the black lever (e) and the foot will disengages.
3
4
Attaching the edge/quilting guide
Attach the edge/quilting guide (g) in the slot as illustrated. Adjust
g
according to need for hems, pleats, etc.
4